View WFL-LP-04N2-A-L_374012.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

NEW
Ultra Small Surface Mount Coaxial Connectors - 1.4mm Mated Height
W.FL Series - Further downsizing of FL series in response to the market needs.
Occupied Mounting Area
2.0
2.0
sFeatures
1. Mounting area of only 3.4mm
2
q Mated Height Comparison(With U.FL series)
2. The board mounted receptacle weights only 5.6 mg 3. Accepts high frequency transmission of DC to 6GHz
(MAX2.0) (MAX2.5) U.FL-LP-040 U.FL-LP-066 U.FL-LP(V)-040 W.FL-LP-040 (MAX1.55) 1.4 1.9 2.4 U.FL Series 2.85 Cable (MAX1.55) Dia. 0.81 W.FL-R-SMT-1 Receptacle
4. Receptacle supplied on tape-and-reel for 4. placement on the board with automatic equipment 5. Plugs are terminated with ultra-fine Teflon(R) 4. insulated coaxial cables 6. Un-mating with a simple tool
W.FL Series
sApplications
Mobile phones, Wireless LAN, Bluetooth protocol devices, PDA, GPS, electronic measuring instruments and any application requiring high frequency transmission over coaxial line, where space is limited.
Plug
* Teflon is a registered trademark of DuPont.
1.4
2004.4
1
sProduct Specifications
Nominal characteristic 50 ohms Operating temperature range -40c to +90c (Relative humidity 90% max.) DC to 6GHz Operating humidity -40c to +70c (Relative humidity 90% max.)
Ratings
impedance Frequency range
sMaterials and Finishes
Item
1. Contact resistance 2. Insulation resistance 3. Withstanding voltage 4. V.S.W.R.(Note)
Specification
Center: 20m ohms max. Outside: 10m ohms max. 500M ohms min., 100V DC 200V AC / 1 minute 1.3 max. (Up to 3GHz) 1.35 max. (3 to 6GHz)
Note:V.S.W.R. Measurement System Note:Measured as shown on the block diagram below. Note:Test connection and measurement setup.
Network Analyzer Test Set Test Port Test Port Cable D.U.T Termination
Note1:Cable type connector measurements. With SMA conversion adapters mated with W.FL plug at each end of the 100cm long ultra-fine coaxial cable. Note2:Board type connector measurements. Mounted on a 50 ohms glass epoxy board. Measurements were conducted with SMA conversion adapters attached.
sMaterial/Finishes
Part
Plug
Component
Shell Insulator Socket center contact Shell
Material
Phosphor bronze PBT Phosphor bronze Phosphor bronze LCP Brass
Finish/Remarks
Silver plated Black, UL94V-0 Gold plated Silver plated Black, UL94V-0 Gold plated
Receptacle
Insulator Pin center contact
sPlug
2
2.85
Plugs can be ordered only terminated to the cable.
2
1.15
sHow to Specify Cable Assembly
Double-ended cable assembly Single-ended cable assembly
***
L(mm)
L(mm)
q Ordering Information
q Standard tolerances for (L)**
(L)(mm)
*L=35 to 200 L=200 to 500 L=500 to 1000
W.FL -- 2LP -- 04N [ ] -- A -- (L)
1 2 3 4 5
Standard Tolerance (mm)
4 8 12 1.5% of (L)
1 Series name 2 Assembly type 3 Cable type 4 Cable color 5 Total length (mm)
L=1000 / W.FL LP2: Single ended 2LP: Double ended 04N: 0.81mm dia. ultra-fine coaxial cable 1: White, 2: Black Length (L)
*Minimum available length (L) is 35mm **Contact nearest HRS representative if different tolerances are required. ***Contact Nearest HRS representative if one end requires preparation.
sReceptacle
BRecommended PCB Mounting Pattern
0.85 0.3 0.25 0.5 1.3 1.7 2 2.6 1.4
1.3
0.3 1.7 2
SIGNAL TERMINAL
1.3
0.65
GND
GND No conductive traces in this area
SIGNAL TERMINAL PAD
Recommended screen thickness: 0.1mm to 0.12mm
Part Number
W.FL-R-SMT-1(10)
CL No.
331-0482-6-10
Packaging
Reel packaging (2000 pieces/reel)
Weight / EA
5.6 mg
1.5
3
sConversion Adapters q SMA Conversion Adapter (W.FL side jack - SMA side plug)
(10.3) 8HEX
W.FL
SMA
Note:Used for performance measurements only. The W.FL mating side has lower retention force than the regular product when mated to the corresponding part.
Part No.
HRMP-W.FLJ
CL No.
311-0367-3
q SMA Conversion Adapter (W.FL side plug - SMA side jack)
13.8 6 SMA O6.35 ( 4.05 ) 5.6
1/4-36UNS-2A
W.FL
Note:Used for performance measurements only. The W.FL mating side has lower retention force than the regular product when mated to the corresponding part.
Part No.
HRMJ-W.FLP
CL No.
311-0368-6
q SMA Conversion Adapter
( 18.35 6 ( 4) ) 5.5
1/4-36UNS-2A
Note:When mating with corresponding part (W.FLR-SMT-1) it must be pressed down and held to make complete connection.
Part No.
HRMJ-W.FLP-ST1
311-0386-8
sReceptacle Inspection Adapter q Used for inspecting the performance parameters of the cable assembly.
12.1 ( 7.9 ) ( 4.4 ) 1 4.2 7HEX
M50.5
Part No.
W.FL-R-1
331-0483-9
O6.35
CL No.
CL No.
4
sPlug Extraction Tool-Used for Un-mating of the plug
( 100 ) 40
5) ( O1
Part No.
W.FL-LP-N
CL No.
331-0492-0
BPackaging Specifications- Receptacle
W.FL-R-SMT-1(10)
Embossed Carrier Tape Dimensions
O1
2 1.75 4
.5
Center contact terminal
12
5.5
8
Unreeling direction
Reel Dimensions
1.8
O1 3
14
O21
O330
5
sUsage Precautions
1. Plugs
1) Mating. 1) Both parts must be aligned on the axis to mate correct. Press down firmly. A tactile "click" will confirm fully mated condition. 2) Un-mating. 1) Fully insert the tool under the plug's flanges as shown. W.FL-LP-N plug extraction tool 1) Apply even force upward until the plug is free.
W.FL Cable Assembly
(1) Mating/ un-mating
W.FL-R-SMT-1
Do not twist, apply excessive forces or sharp bends to the cable.
W.FL-LP-040 Cable Assembly
(2) Cable handling
W.FL-R-SMT-1
Receptacle
2N max
(3) Precautions
Do NOT forcefully twist or deform wires.
2. Receptacles
(1) Recommended soldering temperature profile
c
260 240 220 200 180 160 140 120 100 80
Peak temperature and time 240c 3 seconds
183c Preheating (130c to 165c)
Within 2 minutes 40 to 50 seconds Time
1) The temperature profile indicates the board surface temperature at the point of contacts with the connector terminals. 2) The temperature may vary, depending on the board size, the solder paste type and thickness. (2) Recommended screen thickness 0.1 to 0.12 mm
(R)
5-23,OSAKI 5-CHOME,SHINAGAWA-KU,TOKYO 141-8587,JAPAN PHONE: 81-3-3491-9741, FAX: 81-3-3493-2933 http://www.hirose.com http://www.hirose-connectors.com
6
The contents of this catalog are current as of date of publication. Contents are subject to change without notice for the purpose of improvements.

▲Up To Search▲

Price & Availability of WFL-LP-04N2-A-L

	To Download WFL-LP-04N2-A-L Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .